6
a. Brake cable
b. Cable adjusting screw
c. Adjusting screw lock nut
d. Inner brake cable wire
e. Anchor bolt & nut
NOTE:
If additional brake adjustment is required, you can bring the brake rubbers closer to the wheel
rim by turning the adjusting screw counter-clockwise. To make the brake rubbers further from the rim,
turn the adjusting screw clockwise. Be sure the cable is locked securely through the anchor bolt. Reset
the cable adjusting lock nut when you have finished adjusting.
WARNING:
If
the hand brakes still don’t function properly even after adjustments, contact an
authorized customer service. Do not ride the scooter if the brake does not function properly.
MAINTENANCE
WARNING: Safety can be guaranteed only with proper maintenance.
Bearings:
Make sure you do not ride on water, oil or sand
– the bearings could get damaged.
If you want to maintain the bearings in good condition, regularly check the wheels’ rotation.
Flip the scooter upside down and use your fingers to spin the wheel. If the wheel does not
spin, you need to disassemble it and check its condition. Unscrew the axle first, remove it and
then remove the wheel. Carefully push both bearings out. If the bearings are jagged or
compressed, you need to replace them. If there is no visible damage, the bearings need to be
lubricated. In this situation, use a paper towel or a cloth to remove any lubricant, mud or dust
from the bearing first. Then lubricate the bearings with spray lubricant or petroleum jelly. Install
the bearings, axle and wheel back onto the scooter. Repeat the steps with the second wheel.
Wheels:
Wheels can get worn over time or they can get punctured due to frequent use on a
rough terrain. The rear wheel is more susceptible to wear, because it is used more while
braking. It is recommended to inspect the wheel regularly and in case of wear or tear to
replace them immediately.
Product modifications:
The original product cannot be modified in any way that is not
described in these maintenance instructions.
Nuts, axles and other quick release mechanisms:
We recommend to check these parts
regularly. They can get loose over time. If that’s the case, they need to be tightened again. If
the parts lose their effectiveness completely, they need to be replaced.
TERMS AND CONDITIONS OF WARRANTY, WARRANTY CLAIMS
General Conditions of Warranty and Definition of Terms
All Warranty Conditions stated hereunder determine Warranty Coverage and Warranty Claim
Procedure. Conditions of Warranty and Warranty Claims are governed by Act No. 40/1964 Coll. Civil
Code, Act No. 513/1991 Coll., Commercial Code, and Act No. 634/1992 Coll., Consumer Protection
Act, as amended, also in cases that are not specified by these Warranty rules.
The seller is SEVEN SPORT s.r.o. with its registered office in Borivojova Street 35/878, Prague
13000, Company Registration Number: 26847264, registered in the Trade Register at Regional Court
in Prague, Section C, Insert No. 116888.
According to valid legal regulations it depends whether the Buyer is the End Customer or not.
