4
CAUTION:
Brake gently to avoid skidding or sudden stops. Skidding may cause excessive
wear and damage to the scooter
’s wheels.
Brake will get hot with continuous use, do not touch the brake after braking.
Weight limit:
100 kg
Category:
A
Certification:
EN 14619
ASSEMBLY INSTRUCTIONS
WARNING:
The assembly must be carried out by an adult.
Remove the scooter from the box and make sure no parts are missing or damaged. (The tires come
inflated with air but may lose some air during shipping. Make sure they are inflated to 35PSI.)
Wheel Assembly
Install wheels with axles pushed fully into the axle slots. Make sure to install tab washers (a) so that
the tab is inserted into the round hole in the frame.
(a)
(b)
This washer (a) should be on the outside of the frame, between the frame and axle nut (b). Make sure
the wheels are centered, then tighten the axle nuts (b) firmly with a wrench.
NOTE:
Front and rear wheels are installed the same way. The back wheel may come pre-installed.
During wheel installation make sure the top edge of the brake pad is parallel with the top edge of the
rim of the wheel.
Insert the wheel into the axle slots. Install the tab washer first (a) and then install the axle nut (b).
Tighten with a wrench.
Handlebar Assembly
Install the stem of the handle bars into the fork tube, in a position parallel to the front wheel. Tighten
the stem bolt by using a wrench. Make sure the stem is installed below the maximum height mark.