3
1.
Remote volume control interface: RS‐485 connec
t on interface, used to connect the external commands.
2.
2 linear level balanced output interface.
3.
Mix balance input interface.
4.
Eight MIC balanced input interface.
5.
AC power socket and power switch.
6.
Phantom power switch, to provide a capacitor microphone with 48V phantom power.
7.
Switch voltage selector.
2
.
1 Unpacking Your Unit
Please unpack and inspect your unit for any damage that may have occurred during transit. If damage is found, notify
the transportation company immediately. Only you can initiate a claim for shipping damage.
WARNING
: Before you start to set up your unit, make sure you read and observe the Important Safety Instructions
found at the beginning of this manual.
2
.
2
Installing Your Unit
CAUTION
: Before you begin, make sure your unit is disconnected from the power source and all level controls turned
completely down (counter clockwise).
To install the device in a standard 483 mm (19 inches) audio equipment rack.
We recommend using pre‐built or professionally wired balanced line (two‐conductor plus shield) 22‐24 gauge cables
to connect the balanced input by using the included Euroblock connectors, see Figure 2.3. Unbalanced lines may be
used, but may result in hum or RF noise very long cable runs.
NOTE
: Custom wiring should only be performed by qualified personnel.
2.0
Setup
