Worcraft PROFESSIONAL DWS07-390, Инструкция по эксплуатации

Страница: 41 / 43

OPERATION
Stat / stop the machine
Plug into 230V~,50Hz socket, press the switch trigger to start
the machine, if long time operation, you can press down the
locking knob to lock the switch on the operation status.
To stop the machine, just release the switch trigger or press
again the switch trigger and release it.
Rough sanding on the wet cement wall (See fig. 5)
After put wet cement onto the wall, the wall will be not flat.
Before the wall getting dry, using the machine attached plastic
sanding pad (9) to operate on it, till the wall evenly flat.
NOTE: Before operation, please keep the wall wet enough, if
not, you can spray some water on the wall. Otherwse, it will
very difficult to do that.
Detail sanding on the wet cement wall (Fig.5)
After the rough operation, the wall need to detail operation
further. Change the sanding plate from plastic one(9) to
the sponge pad (7). The replacement method, please
referring the figer 4.
Note: Before detail operation, please spray enough water
on the wall.
Fine sanding on the wall
After above rough and detail sanding, the wall will be flat
and smooth.
Let the wall in good ventilation conditions for some days.
After the wall dry totally, to check the wall status. If the
wall not good enough, you can do the fine sanding on it.
Changing the sanding plate with abrasive paper, then
working on the dry wall.
MAINTENANCE
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth. NEVER
use solvents to clean plastic pats. They could possibly dissolve or otherwise damage the material
●
When the carbone worn out, please have the machine to changing the new carbone brush by expertise man.
ENVIRONMENT PROTECTION
In order to prevent the machine from damage during transport, it is delivered in a sturdy packaging. Most of the packaging
materials can be recycled. Take these materials to the appropriate recycling locations. Take your unwanted
machines to your local dealer. Here they will be disposed of in an environmentally safe way.
Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively
support us in conserving resources and protecting the environment by returning this appliance to the collection
centres (if available).
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents:
EN60745-1:2009/A11:2010; EN60745-2-3:2011/A13:2015; EN55014-1:2006/A2:2011; EN55014-2:2015; EN61000-3-2:2014;
EN61000-3-3:2013; in accordance with t
he regulations 2006/42/ЕEС, 2014/30/ЕEС.
NOISE/VIBRATION Measured in accordance with EN60745 the sound pressure level of this tool is <83,4 dB(A) and the sound
power level is <94,4dB(A) .