User manual
Hoof trimmingcrush:SA0049
Version: 22-12-15
Page 19 of 31
4. Remove the
mudguards
Loosen the locking elements and lift
the mudguard out of the adapter.
5. Tip the crush back.
Tip the crush to the rear so that the
drawbar is clear of the ground. With
the rear gate raised the crush will
remain in that position. Check that the
folding gates are still secured with the
front support feet ropes.
6. Remove the locking
pin from the drawbar.
Rotate the locking pin upwards and
remove it. (Figure 3 :2)
7. Free the drawbar.
Rotate the locking knob and unlock
the clamp situated in the middle of the
drawbar, then slide the nose wheel of
the crush off until the drawbar comes
free from the crush. (Figure 3 : 3)
8. Tip the crush
forwards.
Lift the rear of the crush so that it tips
forwards. The drawbar now rests on
its nose wheel and the ball joint
connection in the box.
Disconnect the drawbar ball
mounting.
9. Tip the axle.
Lift the axle cylinder locking
mechanism.
Operate the valve until the wheels are
folded up.
10. Remove the drawbar.
Remove the drawbar from the crush
and store it out of the way. The shaft
will be held upright by the elastic cord
attached to the ball mounting.
11. Remove the lighting
board.
Remove the lighting board from the
crush.
12. Install the side gates.
Withdraw the side gates from the
crush and place them in the desired
position. (Figure 3 : 4)
