WOOSIM PORTI-P, Руководство оператора

Страница: 24 / 35

Porti-P Rev. 5.0
http://www.woosim.com
2012-05-21
24
< M16C, ARM ( NEW ) Version >
Change the mode and option using the MODE Code.
l
MODE button : use for changing OPTION status. ( Error Lamp )
l
FEED button : use for changing MODE status. ( Power Lamp )
[Example] The defaults of the printer are :
UART / 9600 bps / 8 data bit / No parity / 1 stop bit / Density low
/ Mark use / Sensor low
If a user wants to modify the defaults with
Protocol UART / 57600 bps / 7 data bit / Odd parity / 2 stop bit / Density high
/ Mark no use / Sensor medium1
u
Press
MODE Button
during the Error Lamp flicking 5 times.
® You will see the Power Lamp and the Error Lamp flickers once.
® Press the MODE Button once and the Error Lamp flickers twice.
And then, interface mode has set to Protocol UART mode.
u
When you press FEED button once again, Power Lamp flickers twice and
the Error Lamp flickers once.
® Press
MODE Button
3 times, Error Lamp flickers 4 times.
And then, baudrate has set to
57,600 bps
.
u
When you press FEED Button once again, Power Lamp flickers 3 times
and the Error Lamp flickers twice.
® Press MODE Button once, Error Lamp flickers once.
And then Data Bit has set to 7 data bit .
u
When you press
FEED Button
once again, Power Lamp flickers 4 times
and the Error Lamp flickers once.
® Press MODE Button once, Error Lamp flickers twice.
And then the Parity bit has set to Odd parity bit .
u
When you press FEED Button once again, Power Lamp flickers 5 times
and Error Lamp flickers once.
® Press MODE Button once, Error Lamp flickers twice.
And then the density has set to 2 stop bit .