Woodway 4Front, Руководство по обслуживанию

Страница: 47 / 97

05/2016 – SM-MT-EN-02 47
Perform the following steps in order to properly reinstall the Mercury/Path display:
1. Re-attach all cables.
2. Test the new board, making sure the treadmill operates as expected without issues.
3. Re-install display housing back on the handrail (Pos. 3).
4. Check to make sure there are no loose or extra parts.
6.3 Display-to-Interface Cable Replacement
Standard screwdriver
Phillips head screwdriver
Side cutters
Electrical tape
Ty-wrap, small
Perform the following steps in order to properly remove the display-to-interface cable:
1. Unplug treadmill from power source. Ensure that it cannot be turned back on.
2. Using either standard/Phillips head screwdriver, remove the 6 machine head screws
on the back of the display.
3. Carefully, remove the connector (J6, located between Plug 4 and Plug 5) that plugs
into the display.
4. Remove the side cover located on the AC bracket (right side from running direc-
tion).
5. Remove the trim plate screws, using either standard/Phillips head screwdriver.
6. Using the Phillips head screwdriver, remove the 2 silver screws located on both
ends of the side cover.
7. Once the side cover has been removed, use the side cutters to clip the small Ty-
wrap that secures the cable.
8. Carefully, remove connector J10 from the interface board.
Perform the following steps in order to properly reinstall the display-to-interface cable:
1. Use the old cable to pull the new cable through the handrail (use electrical tape to
connect one end to another). Keep in mind that the cable connector marked “TOP”
must come out of the display end.
2. Ty-wrap the cable to the frame and connect new cable to J10 on the Interface
Board (see Section 4.1).
3. Carefully, plug cable connector marked “TOP” into J6 on display board.
4. Attach display housing to treadmill with six #8 (32 x ½”) Phillips pan head machine
screws and six #8 internal tooth lock washers, being careful not to pinch any wires
or cables as you tighten down the screws.
5. Re-attach the side covers and trim plates.
6. Attach magnet to display.
Installation
Tools Needed
Removal
Installation