Manual 37429
easYgen-2000 Series - Genset Control
Page 24/41
© Woodward
Remote Start/Stop and Acknowledgement
The easYgen may be started, stopped, or acknowledged with Modbus or CAN protocol via the interface. Two
logical command variables are available for this in the
LogicsManager
:
04.13 Remote request
04.14 Remote acknowledge
Configuration of the
LogicsManager
Functions via HMI and/or ToolKit
Start Request in AUTOMATIC Operating Mode
Navigate to the "Configure automatic run" screen by pressing the following softkeys in this sequence:
Parameter -> Configuration -> Application config. -> Automatic run config.
Navigate to the entry "Start req AUTO" by using the and softkeys and press to enter the "Start req
AUTO"
LogicsManager
screen.
Figure 4-12: Example - remote start request
Configure the "Start req AUTO"
LogicsManager
function as above using the and as well the softkey and
confirm the change by pressing the softkey:
With this setting, the "Start req AUTO"
LogicsManager
output becomes TRUE as soon as the remote request
signal is enabled.
Press until you return to the start screen.
NOTE
The
LogicsManager
commands 2 and 3 may be used to configure additional conditions like discrete
inputs, which must be energized to be able to issue the remote start request.
