Manual 37429
easYgen-2000 Series - Genset Control
Page 10/41
© Woodward
Application Mode {1o}
≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡≡
This application mode may be used for isolated operation applications. In this case, the easYgen will function as
an engine control with generator and engine protection. The control unit can only open the GCB.
Figure 2-2: Application mode {1o}
The easYgen requires in all application modes the feedback reply from the circuit breakers. These replies are
used to define, whether it controls frequency, shares the load with other gensets, or performs active load control.
The following feedback signals and commands are used in this application mode and fixed to the respective dis-
crete inputs and outputs:
•
DI 7 "Reply MCB" (mains parallel)
•
DI 8 "Reply GCB" (normally closed (break) contact)
•
DO 6 "Command: GCB open"
NOTE
If the easYgen is intended to be operated in parallel with the mains, the mains voltage measuring in-
puts must be connected.
