15
Parts
PRIOR TO USE
For technical packaging reasons, your machine is not assembled fully. Unpack the appliance
and check that all parts are included. If any part is missing or damaged, contact your dealer
immediately. Dispose all packing material according to local regulations.
Assemble the machine as follows:
1. Attach the base and the base plate with Phillips head screws M5 x 6 mm.
2. Attach the side covering loosely to the base frame using flat-head screws M8 x 40 mm
and nuts. Hand-tighten.
3. Attach the support plate to the left and right side panel with flat-head screws M 8 x 12
and nuts.
4. Attach the housing to the side panels using flat-head screws M5 and nuts (attached to
the housing). Securely tighten all nuts.
5. Slide in the filter bag over the case and attach it with a clamp. Position the support bar
into the housing and hang the filter bag from it.
6. Attach the shavings bag to the lower air ventilator using the clamp.
7. Attach the suction hose to the nozzle on the housing and affix it with a hose clamp.
8. Attach the suction connector to the other end of the suction hose using a hose clamp.
1.
Motor casing
2.
Base with wheels
3.
Left side panel
4.
Right side panel
5.
Base plate
6.
Support plate
7.
Filter bag
8.
Upper clamp
9.
Support bar
10. Container
11. Lower clamp
12. Suction hose
13. 2 x hose clamp
14. Suction connector
