Woodstock W1782, Руководство пользователя

Страница: 10 / 20

Model W1782 34˚ Angle Finish Nailer
-8-
OPERATIONS
Loading
When replacing nails in your Model
W1782, follow these guidelines:
Gauge: ........................................15
Length: ............................. 1
1
⁄
4
" -2
1
⁄
2
"
Capacity: .............................. 40 Nails
Angle: ...................................... 34°
To load your nailer, do these steps:
1.
DISCONNECT NAILER FROM THE AIR
SUPPLY!
2. Insert a nail stick into the T-slot at
the top of the magazine as shown in
Figure 3 .
If you have not read the safety
instructions in this manual, do not
operate the nailer.
Before you operate your nailer, place a
drop of the included oil into the quick
connect fitting where the nailer connects
to the air supply, unless using a lubricator
unit.
To operate your nailer, do these steps:
1.
Connect the air supply to the quick
connect fitting.
2. To test for proper nail penetration,
hold the nailer perpendicular to the
surface of a piece of clean scrap
wood that is thick enough for the
length of nails you have loaded.
3. Depress the safety nose mechanism
against your workpiece.
4.
Before pulling the trigger, make sure
your free hand and other body parts
are positioned out of the way of a
potential path of a nail in case of
deflection.
Deflection is caused when grain
irregularities, knots or foreign objects
inside the wood cause the nail to
change its path, resulting in the
nail puncturing the surface of the
workpiece, as shown in
Figure 4 .
Operating
4.
Pull the magazine pusher all the way
back, then let it come forward until
it rests against the end of the nail
stick.
3. Slide the nail stick all the way down
to the nose of the nailer.
Figure 3. Loading finish nails into nailer.
Pusher