Woodstock SHOP FOX W1752 s, Руководство пользователя, Страница: 23 / 40

-21-
W1752 Owner's Manual (Mfg. 1/07+)
O
PE
R
ATIO
NS
Spindle Turning
Spindle turning (
Figure 18
) is the operation performed
when a workpiece is mounted between the headstock and
the tailstock.
To set up a spindle turning operation, do these steps:
1.
Mark both ends of your workpiece by drawing diago-
nal lines from corner to corner. The intersection
point of these lines will show you the center of your
workpiece. See
Figure 19
for details.
2.
Using a wood mallet, tap the point of the spur
center into the center of the workpiece, so that it
leaves a center mark, then remove the spur center.
3.
Using a
1
/
8
" drill bit, drill a
3
/
16
" deep hole at the
center mark.
4.
Cut the corners off your workpiece if it is over 2" x
2" to make turning safer and easier.
5.
Drive the spur center into the center of the
workpiece with a wood mallet to embed it at least
1
/
4
", as shown in
Figure 20
.
Figure 18
. Typical spindle turning opera-
tion.
Figure 19 . Workpiece marked diagonally
from corner to corner to determine the
center.
1 /
4
"
Figure 20 . Spur center properly embed-
ded.