Woods TS1680, Руководство оператора

Страница: 45 / 82

Assembly 45
MAN0577 (6/26/2007)
Figure 32 . Light Kit Installation
INSTALL LIGHT KIT (OPTIONAL)
1. Drill two 1/2" holes through both outer deck
channels using dimensions shown in Figure 32.
2. Drill two 11/64" holes into deck plate as shown.
3. Install electronic module (4) to deck using self
tapping screws (6).
4. Route wires as shown. Be sure wire labeled "Left"
is routed to the left light.
5. Install light brackets (3) on outer deck rails as
shown. Secure with cap screws (9), washers (10)
and lock nuts (11).
6. Secure left and right lamp (1 & 2) to brackets (3)
using cap screws (7) and lock nuts (8) as shown.
7. Connect lights to wire harness (4).
8. Route main wire along hydraulic hose and secure
to hose using wire ties (5).
INSTALL STUMP JUMPER (OPTIONAL)
1. Remove blade pins and blades from crossbar.
2. Remove straps (2) from stump jumper (1).
3. Insert blade pin through blade, stump jumper (1)
and crossbar. Reinstall spacer on blade pin and
install new jam nut.
4. Attach straps (2) to stump jumper (1) and crossbar
using carriage bolts (3), washers (4), lock washers
(5) and hex nuts (6).
Figure 33 . Stump Jumper Assembly
1. Left light assembly (not shown)
2. Right light assembly (not shown)
3. Light bracket
4. Electronic module
5. 7" Tie strap
6. #10 x 1/2 Self-tapping screw
7. 1/4 NC x 1 HHCS GR5
8. 1/4 Lock nut
9. 3/8 NC x 4 HHCS GR5
10. 3/8 Flat washer
11. 3/8 NC Flange lock nut
12. Wire harness
3. 5/8 NC x 1-1/2 Carriage bolt
4. 5/8 Standard flat washer
5. 5/8 Heavy lock washer
6. 5/8 NC Hex nut
(Rev. 8/31/2007)