3
© 2011 Woodpeckers
®
Inc. Rev 10-2011
Step 6a.
STEP 6: Installing the Fence.
After both fence mounting blocks have been installed and all
four knobs are still loose, orient the fence so that the two-slot
side is facing up as shown in 6a. You'll know it's right if you can
read the scale. To attach the fence, slide it under the overhang
of the each block by aligning the bolt head so it'll fit into the rear
most slot in the fence.
While squeezing the fence and block together, tighten the front
knob and repeat for the other bracket.
Once the front knob in each block is tight, slide the fence back
so it's just behind the filler piece (or recess). Tighten the remain-
ing knob in each block. When this step is complete, it should
look like the illustration in 6b.
Two-slot side face up.
STEP 7: Installing the L-Stop.
Slide the hex bolt into the forward most slot in the fence. Set
the L-stop onto the bolt. Install a nylon washer and thread on
the knob. The stop can be positioned wherever needed and
aligned with the scale engraved on the top of the fence.
Step 7.
Align bolt head with T-slot.
Step 6b.
OPTIONAL ACCESSORY
Flip Stops
Optional Flip Stops
Flip Stops are available as an alternative or in addition to the
standard L-stops. They install in a similar manner. First slide the
bolt in from the end of the fence, set the Flip Stop down over
the bolt and tighten up the knob.
Once in place, simply lift the arm
to rotate it up out of the way.
