2
© 2011 Woodpeckers
®
Inc. Rev 10-2011
STEP 5: Install the Fence Mounting Blocks.
First insert the 1
"
hex bolt up through the fence mounting block
as shown. Loosely start a black knob onto this bolt. Then slide
the 1
¼"
hex bolt into either T-slot in the table track. Set the
block onto the bolt. Loosely start the other black knob.
Repeat this same procedure for the mounting block in the
other track.
The four coarse thread screws and the four oval nuts can be
used for this approach. However you'll need to supply the bolts
needed for attaching the adaptor board to your drill press table.
Your bolts should match the
5
⁄
16
-18 thread of the oval nuts. The
oval nuts fit into most drill press table T-slots. Match them up
with bolts that are of the length necessary to attach the adaptor
board without bottoming out in the slot.
Begin by selecting four locations for mounting bolts. Accurately
mark these locations ensuring that they are perfectly centered
to the T-slots.
The through holes should be about
3
⁄
8
" in diameter. Illustration
3b shows counter bored holes made with a forstner bit and a
standard
3
⁄
8
" drill bit. Counterbored holes are best for hex head
bolts. If you plan on using flat head screws then substitute a
counter sunk hole instead of a counter bored one. Most hard-
ware stores sell countersink bits for this purpose.
Once you've attached the adaptor board to your drill press ta-
ble, use the four coarse thread screws and washers to attach
5
⁄
16
-18 Oval nuts.
(Included.)
Coarse thread screws.
(Included).
Mounting bolts.
(Not included.)
Step 3b.
Use counterbored or counter
sunk holes for mounting the
adaptor board.
the new table to the adaptor board. This will require pre-drilling
5
⁄
32
" diameter holes into the bottom of the table and
7
⁄
32
" holes
through the adaptor board.
New table.
5
⁄
32
pilot hole.
7
⁄
32
Thru hole.
Adaptor board.
Original table.
Step 3c.
STEP 4: Install Filler.
Four small screws are provided to serve as leveling screws for
the filler piece. Step 2 describes their installation. If you haven't
already done so, install them now. Then set the 4 x 4 x ½ filler
into the recess. This is a sacrificial piece that can be easily re-
placed to minimize tear out as the drill bit exits the material.
Step 4.
Step 5.
Black knobs.
Fence mounting block.
1
¼"
Hex bolt.
1
"
Hex bolt.
