3/5
www.woodlineshade.com Toll Free 1 – 800 – 260 – 0617
Ball Stud
RIB
release LOXX fastener
Top half of
LOXX fastener
Bottom of
LOXX fastener
lift top of
LOXX fastener
place LOXX fastener over ball stud
STEP 1
A After assembling the base, remove the umbrella from the protective bags and set umbrella down on top of the bag to
keep the canopy clean during the assembly.
B Loosen the fastening wheel(s) on the tube attached to the base, lift the umbrella and slide the pole into the tube. Turn the
fastening wheel(s) clockwise until tight to secure the umbrella in the tube.
STEP 2
A Remove the protective cardboard ring from the bottom of the ribs.
B To attach the canopy ends to the rib ends, use your fingers to pull the top half of the LOXX fastener up, and place onto
the ball stud mounted on the rib. Release the top half of the LOXX fastener. Repeat until all corners are attached.
TO OPEN AND CLOSE THE UMBRELLA
NOTE:
Before opening the umbrella structure, loosen the umbrella strap and pay close attention to how the canopy has been
folded. It is essential to always fold the canopy in this manner with every closing to ensure fabric does not get pinched by the
ribs in the collapsed position.
Not folding the canopy properly will cause abrasion to the fabric, which is not covered in
the manufacturer’s warranty.
A Untie the canopy strap that secures the canopy frame in the closed and folded position.
B If the umbrella won’t open do not force it or damage may occur. If the umbrella does not open easily, it is because one of
the rib connection points has been pushed in towards the pole and is locked in position. Slightly open the umbrella by
inserting your fingers into the ribs and opening them slightly to allow free movement of the rope and to push the ribs away
from the pole.
C After making sure none of the ribs are locked, grab the rope and pull down to open the umbrella. Pull on the rope until the
bottom hub is above the stop pin hole located on the top half of the mechanism and push stop pin through the hole.
To close the umbrella pull down on the rope until the bottom hub is clear of the stop pin, remove the stop pin and lower the
umbrella. Always fold and strap the canopy when the umbrella is not in use, or unattended. Damage can result from abrasion
caused by wind if the umbrella is left closed and not properly folded and strapped. See canopy folding instructions
for proper folding instructions.
SWIFT 29/11/18
Removal and installation of LOXX® upper parts and lower parts with
washer (if you wish to wash your canopy).
Use the supplied LOXX Spanner to remove and replace the LOXX
the upper or lower part. The system won‘t close correctly if the washer
Locking Pin
Hook for coiling of rope
Glass filled nylon hub
