Woodland Mills WC88, Руководство пользователя

Страница: 18 / 36

MAINTENANCE & SERVICE
REPLACING BLADES
Follow these steps to replace the blades. The WC88 wood chipper uses four (4) hardened
steel blades. The blades are reversible and are 2.75” x 4.5” x 0.3125”
(70mm x 114mm x
8mm) in size.
1) If installed, the PTO shaft should be disconnected from the tractor for safety.
2) The upper flywheel housing can be opened to access the blades by using a 24mm
wrench to remove the bolt holding the two halves together.
3) With the flywheel now exposed, rotate it so that there is access to the first blade.
Using a 17mm wrench or socket on the nut and a 6mm allen key on the bolt, remove
the two bolts holding the blade onto the flywheel. Ensure that you do not drop the
nuts or bolts into the bottom of the flywheel housing. If this occurs, a long pen
magnet can be used to retrieve them.
4) Repeat step 3 to remove the other three blades. At this point, the blades can be
reversed to utilize the other cutting edge or the entire blade can be removed and
either sharpened or replaced with new blades. If the blades are going to be
sharpened, please see the instructions in the next section of the manual.
5) Close the upper flywheel housing and tighten the bolt to secure it to the lower
flywheel housing.
Page of 17 34