1
2
PLANING
Here we describe how to plane a part using
Option A
described earlier. Make adjustments as necessary if using
Option B
, or
Option C
. Loosen the two rear ratchet handles
and adjust the rear Double Track so the part is sandwiched
between (with a small gap) the front and rear Double Tracks.
Before using, make sure the Planing Sled moves freely
from side-to-side on the wood rails and the Router Sled
moves freely (but without excessive slop) between the Ultra
Tracks from front-to-back.
Never allow the center of the Router Sled to go past the
center of the wood rails or the Planing Sled could tip off the
wood rails.
When planing narrow parts, verify that the weight of
the overhanging Ultra Track rails will not tip the Planing
Sled off the wood rails. If necessary, you may need to make
an additional wood rail to support the outer ends of the Ultra
Track rails.
Install the necessary bit
(must have at least a 2-1/2"
overall length)
in your router and attach the router to the
Router Sled. Set the depth of cut to 1/8" or less. Set the stops
on the Ultra Track rail to control the front-to-back movement
of the Router Sled.
Wide parts may require you to complete one side of
the part before doing the opposite side. Never try to reach
beyond a comfortable and safe distance. Always work
against the rotation of the bit - never climb cut! Always take
appropriate safety precautions.
Make a pass
(Step 1)
moving the router front-to-back or
back-to-front
(as needed so as not to climb cut)
snd turn the
router off. Slide the Planing Sled to the left or right
(Step 2)
approximately 1/8" less than the cutting diameter of the bit
you're using and repeat Step 1.
If you don't frequently adjust the Brackets/Double
Track for varying part widths, you can substitute the 5860
Ratchet Handles with 1/4-20 nuts, not provided.
6
