A
B
C
6.2 Drive Belt Check
The cutterblock drive belt and the feedgear drive belt need to
be checked periodically and retightened if necessary. Both drive
belts are located behind the machine's side panel.
Checking the drive belt:
1. Unplug power cable.
2. Pull the fence (A, Fig.19) forward.
3. Take off the the side panel (B, Fig.19) and belt cover (C,
Fig.19).
4. Check belt tension with thumb pressure. The drive belt should
not give more than 10 mm in the centre.
Tensioning the drive belt:
5. From outside the machine, loosen the four nuts (D, Fig.20) –
using stick (E, Fig.20) to increase the motor, the cutterblock drive
belt will be slackened.
CAUSTION: When increase the motor by stick, don't damaged
the motor wiring box.
6. To tension the cutterblock drive belt, push the motor downward.
When belt tension is correct tighten motor mounting nuts (D,
Fig.20).
7. If necessary, remove chips and dust with dust collector or
brush.
8. Replace the side panel and belt cover secure with the screws.
FIG. 19
D
E
FIG.20
-12-
