Woodbridge DV2500-E, Инструкция по установке и эксплуатации

Страница: 28 / 48

ELECTRICAL INSTALLATION
ELECTRICAL WIRING
Electrical connections should only be performed by a qualified, licensed electrician. Main
power must be off when connecting to main electrical power supply or performing service.
All wiring shall be in compliance with all local, city, and state codes. The appliance,
when installed, must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the
National Electrical Code ANSI/ NFPA 70 (latest edition)
and Canadian Electrical Code, CSA C22.1.
WARNING
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
CAUTION
FAN ASSEMBLY DIAGRAMS
Speed Control Control Shaft
Control
Knob
Switch
Bracket
Blower
Plug-In
Duplex Outlet
(Located underneath
firebox floor against
Blower Location
Side View
Strips
Exhaust Port
Screw
Green
Ground
Wire
Spade
Terminals
Lower Firebox Cavity
FR
ONT
BA
CK
(see page 5)
BLOWER/FAN LOCATION
lower right outside wall, as shown on page 5)
Velcro
2
8
This fireplace requires 110V AC electrical supply for normal operation in order to power up blower and 7V DC
adapter which is required to operate Remote Control. However, during power outage situation, its electronic
system (DFC board) can be temporar
il
y powered with
6
V DC bat
t
ery
pack (4 AA batteries).