A.G.A. Design-Certified
Manual Shutoff Valve
With 1/8” NPT Tap
Cap Pipe Nipple Tee Joint
Sediment Trap
3” Minimum
CONNECTING TO GAS
SUPPLY
Installation Items Needed
pliers
-
sediment trap
-
tee joints
-
pipe wrench
Installation must include a manual
shutoff valve, union, and plugged
1/8” NPT tap. Locate NPT tap
within reach for test gauge hook
up. NPT tap must be upstream
from the appliance.
Apply pipe joint sealant lightly to
male threads. This will prevent
excess sealant from going into
pipe. Excess sealant in pipe could
result in a clogged burner injector.
Install sediment trap in supply line
as shown below. Locate sediment
trap where it is within reach for
cleaning and trapped matter is not
likely to freeze. A sediment trap
CHECKING GAS
CONNECTION
Test Pressures in Excess Of
1/2 psi (3.5 kPa)
Test Pressures Equal To or
Less Than 1/2 psi (3.5 kPa)
WARNING:
A qualified
service person must con-
nect appliance to gas sup-
ply. Follow all local codes.
WARNING:
Test all gas
piping and connections for
leaks after installing or
servicing. Correct all leaks
at once.
WARNING:
Never use an
open flame to check for a
leak. Apply a mixture of
liquid soap and water on all
joints.
Bubbles forming
show a leak. Correct all
leaks at once.
From Gas Meter
(5” W.C. to 10.5” W.C.
pressure)
The appliance and its individual
shutoff valve must be discon-
nected from the gas supply piping
system during any pressure testing
of that system at test pressures in
excess of ½ psi (3.5 kPa).
The appliance must be isolated
from the gas supply piping system by
closing its individual manual
shutoff valve during any pressure
testing of the gas supply piping
system at test pressures equal to or
less than ½ psi (3.5 kPa).
Approved Flexible
Gas
Connector
IMPORTANT
Flexible Gas Connectors.
Before installing the Outdoor
items listed bellow:
-
piping (check local codes)
-
sealant
-
manual shutoff valve
-
adjustable (crescent) wrench or
traps moisture and contaminants.
This keeps them from going into
If sediment trap is not installed or
is installed wrong, unit may not
run properly.
GAS CONNECTION
8
Log Set
, make sure you have all
Outdoor
Log Set
controls.
CAUTION:
Use only new,
black iron or steel pipe.
Internally tinned copper
tubing may be used in
certain areas. Use pipe of
1/2" diameter or greater to
allow proper gas volume to
the Gas Log Set
.
If
pipe is too
small, undue loss
of pressure
will occur.
This appliance is not designed
for use with a non-disposable,
self-contained propane as
supply system! Do not use a gas
hose to connect the appliance
to any gas supply. Use approved
