Gas Plancha Installation and Operation Manual
An ongoing program of product improvement may require us to change
specifications without notice.
WS-GPL-4836-CT Gas Plancha
or visit
woodstone-corp.com
Wood Stone Corporation
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
Toll Free 800.988.8103
Tel 360.650.1111
Fax 360.650.1166
9
M0202.00 January 2017
CLEAN THOROUGHLY BEFORE FIRST USE
A vegetable oil cooking spray is applied to the cook surface at the factory to help protect from corrosion during shipping� The cook
surface must be thoroughly cleaned before use� Follow these instructions:
1.
Make sure the Grease/Debris Trays are in place�
2.
Turn the Plancha ON and allow to heat for 5 minutes� Then turn the Plancha OFF and wait for 5 minutes�
3.
Wipe the cook surface using a wet towel, dampened with a small amount of water and a mild dish detergent� Then rinse with a
towel dampened with clean water 3-4 times� Wipe the surface down with a dry towel and the Plancha is ready for service�
CAUTION: THE COOKING SURFACE WILL BE HOT!
USE CAUTION WHEN WIPING SURFACE,
PAYING PARTICULAR ATTENTION TO AVOID STEAM FROM DAMP TOWELS.
BASIC OPERATION
Use the Power Switch on the Front Panel to turn on the Plancha� This appliance utilizes an automatic ignition system—there are no
standing pilots to manually light� Press the Power Switch to the OFF position to turn off the Plancha�
At start-up, the red RESET light next to the Power Switch will be illuminated until the automatic ignition system has successfully lit
the pilot� This is typically not more than a few seconds� However, when initially starting the unit up after installation, pilot ignition
will likely take longer while air in the gas line purges—the light will remain illuminated until the pilot lights�
NOTE
: If the red
RESET light illuminates during operation of the Plancha, turn the power switch to the OFF position, wait 5 minutes, then restart the
Plancha�
When the Plancha is first turned on the Heat Indicator Light for each zone will be illuminated until its zone reaches the
temperature set on the Temperature Control Knob (appx 18–20 minutes)� After the set temperature has been reached, a Heat
Indicator Light will only illuminate when the temperature of its corresponding zone has dropped below the temperature set on the
Temperature Control Knob� For example, an Indicator Light may illuminate after a large food load is placed on the cooking surface�
The Plancha Controller automatically adjusts the runtime of the burners suppling heat to each zone to maintain the set point
temperature�
BASIC OPERATION
ON/OFF switch
Red RESET light
4 Heat
Indicator Lights
Grease/debris trays
PL-4836-4-CT
