Wood-mizer LT40L DH, Руководство по обслуживанию

Страница: 39 / 133

Setup & Operation
Portable Sawmill Setup
Setup & Operation doc041118 2-6
2
3. Unhook the carriage safety chain, located at the bottom of the vertical mast.
4. Turn the key switch on the control panel to the accessory (#3) position to enable accessories. Use
the up/down switch on the control panel to raise the cutting head from the carriage rest pin. Remove
the locking pin and swing the rest pin down below bed level.
WARNING! Failure to put front outrigger down before moving cutting
head from the rest position may result in serious injury.
5. Remove the fenders by lifting them out of the slots.
CAUTION! To prevent fender damage, remove fenders before
operating sawmill or loading logs.
6. Use the carriage forward/reverse switch (left side of control box) to move the cutting head toward the
front end of the mill. Lower and set the remaining rear outriggers.
7. Lower and set the remaining rear outriggers. Level the sawmill by turning each outrigger adjustment
bolt clockwise to raise a given sawmill end, or counterclockwise to lower it. Adjust all outriggers
evenly to avoid twisting the mill frame by jacking one outrigger higher than the others.
8. Raise the side supports to prevent the log from falling off the side of the mill when loaded.
See Figure 2-4.
FIG. 2-4
Pivot Bed Rail
Bed Rail
Stop Block
Side Support
5000063