Wood-mizer LT15 M2-3 E11S, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 77 / 108

Setup & Operation
Transporting the Sawmill
Setup & Operation 15doc121912 3-27
3
3.15 Transporting the Sawmill
The assembled sawmill can be transported in an appropriately equipped pickup truck:
1.
Adjust the cutting head up just far enough so it will clear the sides of your truck bed when loaded. Do not
adjust the cutting head so high that the sawmill will tip easily while being loaded.
2.
Move the cutting head to one end of the bed frame. Engage the travel lock pin to prevent the cutting head
from moving. Pull the pin and rotate and release so the roll pin seats in the locking position notch.
See Figure 3-8.
3.
Remove the leg assemblies or adjust them above the bottom of the bed frames.
4.
Position the bed of the truck at the end of the frame opposite the cutting head.
5.
While two people lift the end of the frame without the cutting head, back the truck under the sawmill until the
the end of the frame is resting firmly on the bed of the truck.
6.
With a person positioned on either side of the cutting head, disengage the travel lock pin. Push the cutting
head up the bed frame and engage the travel lock pin in the end of the frame in the truck bed.
7.
Use two people to lift the end of the mill still on the ground and slide the sawmill into the truck bed.
WARNING!
Keep all persons out of the path of the cutting head while
loading and unloading the sawmill. Failure to do so may result in serious
injury or death.
8.
Secure the sawmill to the truck bed to prevent the sawmill from shifting while it is being transported.
FIG. 3-8