Wood-mizer EG400EH30S, Руководство пользователя

Страница: 73 / 133

Maintenance
Tensioning the Belts
Maintenance IE doc122719 4-8
4
NOTE! Do not over tighten the drive belt as it can cause
premature belt and/or bearing failure.
NOTE! Do not under-tighten the drive belt as it can cause
one or all of the following damages: slippage of the belt on
the drive pulley, binding or fetching up of the saws while in
the cut, damage or bending of saws.

Retighten the motor mounting nuts when done.

Close and secure the blade drive side removable guard.
2. Check the laser light box timing belt for wear every 8 hours of operation. Tension or
replace if necessary. The belt tensioner should be adjusted closely enough to remove any
belt slack. Do not overtighten.
See figure 4-7. To tension the laser light box belt:

Locate the adjustment pulley in the laser light box. Loosen the mounting nut secur-
ing the adjustment pulley.

Push the adjustment pulley up or down until the belt is tensioned as needed.

Retighten the adjustment nut to secure the adjustment pulley when done.
FIG. 4-7
IE0024
Timing Belt
Mounting Nut
Adjustment Pulley
Mounting Nut
Adjustment Pulley
Timing Belt