Setup & Operation
Blade Height Sight Gauge
2
2-22
2596doc091809
Setup & Operation
2.14 Blade Height Sight Gauge
NOTE:
Sight gauge supplied on LT25 through B7526LT30 through F4731 & LT40
through F5611LT30HD through F8522, LT40HD through F8458 & LT40HD Super
through F8522 only.
See Figure 2-12.
The sight gauge is provided on the cutting head carriage to help you
decide where to make the first cuts on a log.
Move the carriage forward until the blade is close to the end of the log.
Position yourself so that your eyes are level with the bottom of the sight gauge spring.
With one eye closed, move your head up or down until the bottom of the sight gauge is
lined up with the bottom of the blade.
Sight down the length of the log. You should be able to see where the blade will pass
through the log down its entire length. Raise or lower the cutting head until you get the
blade height you want.
HINT:
After judging by eye where you want to make your first slab cut, check the scale.
Move the up/down crank to fine-tune the blade height to an even measurement on the
blade height scale.
Example:
Adjust the blade up to 15" rather than cut at 14 13/16". This will make adjust-
ments for the next cuts easier to figure on the scale.
FIG. 2-12
Sight gauge eye-level
with bottom of blade
SM0047
Содержание 1996 LT25
