16
Commercial Series Cyclone Owners Manual
April 2012
Warranty
WARRANTY TERMS
The Warranty shall also be subject to the following terms and conditions:
I. The System must have been installed by a Certified Contractor.
II. The System must have been properly maintained, cleaned and serviced during the Warranty Periods by a certified
boiler operator trained to operate a WoodMaster Commercial Series boiler.
III. This Warranty is non transferable and only covers the Original Owner, at the original site of installation.
IV. Northwest Manufacturing, Inc. shall have the time needed and unobstructed access to the System for the purpose of
conducting tests of the System and for the making of repairs or installation of replacement parts.
V. Repairs, replacement or the repair of replacement parts shall be subject to the terms and conditions of this Warranty
as if they had been installed at the time of original installation.
VI. This Warranty is limited to the provisions previously described and does not extend to any boiler, related parts or
products that are (a) not sold in Canada or the United States; (b) not installed in Canada or the United States; or (c) not
purchased from an Authorized Distributor.
VII. Northwest Manufacturing, Inc. shall not be responsible for any consequential damages, direct or indirect caused by
the products described in this Warranty.
VIII. The Warranty for this System is also subject to the terms of the Warranty for the WoodMaster Commercial Series
Boiler.
APPLICABLE LAW
All disputes, claims or demands arising from or relating to Warranty described shall be determined in accordance with
the laws of Red Lake County, Minnesota, USA.
WARRANTY CLAIM/SERVICE
Notify the Certified Contractor who installed your System. The Contractor will then notify Northwest Manufacturing,
Inc. who will make all warranty decisions. No warranty work can be carried out without approval from Northwest Manu-
facturing, Inc.. If the Certified Contractor fails to make a warranty claim, contact Northwest Manufacturing, Inc. directly.
Allegedly defective parts MUST be returned to Northwest Manufacturing, Inc. for the purpose of inspection to deter-
mine cause of failure.
Northwest Manufacturing, Inc. / 600 Polk Ave. SW / Red Lake Falls, MN 56750-5002
(800) 932-3629 • Fax: (218) 253-4409 / www.woodmaster.com
