Wood Energy Solutions E-COMPACT 40, Руководство по установке и эксплуатации

Страница: 12 / 34

3.4. CONNECTION OF THE FLUE
WES recommend that the Therminox range of stainless steel insulated flue pipe is used with this
product. A full range of straight, offset, elbow and ‘T’ elements is available to overcome any
obstruction which the flue should avoid. The proper draught conditions in the flue is critical for
the efficient working of wood pellet boilers. The flue can exit the boiler house/garage through the
roof or through the wall by using a bend on the flue. The combustion chamber works in negative
pressure. The smoke duct for the discharge of fumes will also be under negative when connected
to an efficient flue pipe as directed.
All sections of the flue must be capable of inspection and removable to enable
periodic internal cleaning.
Position the appliance bearing in mind all the instructions and considerations above.
IMPORTANT!
All 90 degree changes of direction in the flue pipe must be either removable or
capable of inspection. For locating the boiler against a wall ensure adequate
flue support using approved wall brackets.
THE FLUE MUST AVOID HORIZONTAL RUNS EXCEPT WHERE IT MUST PENETRATE A WALL INTO A
‘T’. IT IS ALSO ADVISABLE NOT TO EXCEED 8 METRES IN LENGTH WITH THE PIPE Ø 150 mm
ECOMPACT 40
Page 10
Pre-Installation Considerations
© Wood Energy Solutions
woodenergysolutions.co.uk
THE WEIGHT OF THE FLUE SHOULD NOT BEAR
DOWN ON THE BOILER. THE SECTION OF FLUE
JOINING THE BOILER MUST BE REMOVABLE SO AS
TO REMOVE THE TOP OF THE BOILER FOR
CLEANING THE SECONDARY HEAT EXCHANGER
TUBES. FAILURE TO DO SO WILL INVALIDATE THE
WARRANTY.
WES recommends the use of 150mm Therminox
flue for use with this appliance.