12
EWSJ Series Outdoor Speed PTZ Dome Camera System User
’s Guide
13
EWSJ Series Outdoor Speed PTZ Dome Camera System User
’s Guide
4. 1 Powering On
When turning EWSJ series camera power on, there is a ten (10) second pause before the camera starts
its homing phase. During the homing phase the camera pans left and right and tilts up and down. It also
adjusts the lens focus.
4. 2 Establishing Camera Control
The most common way to interface with the camera is using a keyboard and on-screen display (OSD)
menu. This method is the most common and is covered in this manual.
4. 2. 1 Basic Keyboard Operation
The following tables summarize the basic operations for a standard keyboard and the functions available
to control EWSJ series.
Table 1. 1 Typical Keyboard Functions
Table 2. 1 Typical Keyboard Controls for EWSJ series speed PTZ dome camera system
4. ON-SCREEN DISPLAY PROGRAM MENU
Typical Keyboard Features
Usage
Function Keys
Number Keys
Camera Key
Enter Key
Focus Key (Or Near Key)
Iris Key
Key LEDs
LCD
Joystick
Selects a specific control setting
Inputs a number from 0 to 9.
Selects a camera number
Inputs a selection
Sets the lens focus or make a menu selection in OSD menu.
Sets the lens iris setting or makes a menu selection in OSD mode.
Indicates an active key
Displays the current status
Controls a pan/tilt/zoom (PTZ) EWSJ series
Dome Operation
How to Control
To Pan Side to Side
To Tilt Up and Down
To Zoom In
To Zoom Out
Move the joystick left or right.
Move the joystick forward and back.
Twist the joystick clockwise.
Twist the joystick counterclockwise.
EWSJ series is programmed through the on-screen display (OSD) menus.
To access the OSD menus, you must open the main Setup Menu.
①
②
③
④
①
②
③
④
3. 3 Wall Mounting
①
Insert the dome drive to the dome body and connect the cables as shown in the above diagram.
②
Assemble the dome cover to the dome body by pressing the cover gently downward to the
dome body with two hands on the side of the cover. Do not press the cover with strong pressure.
This might cause damage to the dome body.Screw the dome cover and body together.
③
Install the bracket on to the wall to install the camera and prepare for the wire with connector.
For easy installation, screw the three safety screws slightly.For the safety reason, turn off the
main power during the installation. Connect the cable with the assembled dome system.
④
Put the dome system into the bracket. Fasten the 3 installation screws as shown in the above
diagram.
3. 4 Ceiling Mounting
①
Insert the dome drive to the dome body and connect the cables as shown in the above diagram.
②
Assemble the dome cover to the dome body by pressing the cover gently downward to the
dome body with two hands on the side of the cover. Do not press the cover with strong pressure.
This might cause damage to the dome body.Screw the dome cover and body together.
③
Make a hole in the ceiling to install the camera and prepare for the wire with connector.
For easy installation, screw the three safety screws slightly.For the safety reason, turn off the
main power during the installation. Connect the cable with the assembled dome system.
④
Put the dome system into the bracket.
Fasten the 3 installation screws as shown in the above diagram.
