8
7. CERAMICS INSTALLATION
7.1
Make sure that the
tray trim is fitted over the
front edge of the burner
tray and that it is pushed
fully down. See figure 13.
Place the front base coal in
the burner compartment
so that it rests on the
ledges at the sides and
front. Pull the coal forward
so that it is immediately
behind the front rim of the
burner compartment. (See
figure 13)
.
7.2
Place the rear
base coal in the burner
compartment behind
the front coal. It should
rest on the ledge at the
back of the burner
compartment and its
rear face should touch
the rear ceramic wall
(See figure 14)
7.3
Install the 15
loose coals as follows.
The smooth surfaces of
the coals should be at
the bottom and back.
7.3.1
Select the four
rectangular shaped coals
and position two on each
side of the base ceramics.
See figure 15.
7.3.2
Place four of the
remaining coals in the four
valleys of the front coal.
Place the left side coal so
that the pilot flame will be
visible. See figure 16.
7.3.3
Place three of the
remaining coals behind
the front row and
approximately midway
between the front row
and the rear ceramic
wall of thefirebox. See
figure 17.
7.3.4
Place the four
remaining coals along the
back ceramic wall. See
figure 18.
Figure 18 Rear coals
Figure 17 Middle row of coals
Figure 15 Side coals
Fig. 14 Rear base coal
installation
Fig. 13 Tray trim & front base
coal installation
Figure 16 Front row of coals
