INSTALLER’S GUIDE
Page 12
Figure 11. Fitting the coal support plate
Figure 10. Lower Cable Retention
Figure 9. Cable Route
6.
Thread the cables through the eyebolts. Return
the cables through the holes near the bottom of the
convector box back panel, and through the “V”
shaped brackets near the bottom front sides of the
convector box - See figure 9.
7.
Place the convector box fully back into the
fireplace opening so that it is sealed against the
fireplace front.
8.
Fit a cable retainer over the bottom end of each
cable.
9.
Pull each cable taut. Push the cable retainers
hard up against the “V” brackets. Tighten the
screws in the retainers so that they clamp the cables
in position. Apply tension to the cables by turning
the hexagonal adjusters by hand. See figure 10.
10.
Inspect the installation of the convector box
against the fireplace surround. If the
convector box is aligned squarely
and the sealing is satisfactory, fully
tighten the cable retainers.
11.
If the convector box is not
correctly aligned, release the tension
on the cables by slackening the
screws and turning the hexagonal
adjusters fully anticlockwise. The
convector box should then
automatically realign itself. Pull each
cable taut again and push the cable
retainers back against the “V”
brackets. Again, tighten the screws in
the retainers and apply tension to the
cables by turning the hexagonal
adjusters clockwise as far as possible.
12.
Feed the free length of the cables
into the gap above the brackets so that
they are available to allow easy
removal and refitting of the appliance
during subsequent service calls.
Do
not cut off the free lengths of cable
