21
PART 8: FITTING THE CERAMICS
1
With its feather
edge at the top, place the
ceramic rear wall into the
channel at the back of the
firebox. Push the wall flat
against the rear of the fire
box. (See figure 33).
2
Make sure that
the tray trim is fitted
over the front edge
of the burner tray
and that it is pushed
down fully (see
figure 34).
Place the front base
coal in the burner
compartment so that
it rests on the ledges
at the sides and
front. Pull the coal
forward so that it is
immediately behind
the front rim of the
burner
compartment. (See
figure 34)
.
3
Place the
rear base coal in the
burner compartment
behind the front coal. It
should rest on the ledge
at the back of the burner
compartment and its
rear face should touch
the rear ceramic wall
(See figure 35)
4
Install the 9 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
4.1
Select the two
smallest coals and put
them aside until all the
other coals are installed.
Place four of the medium
size coals in the four
valleys of the front coal.
Place the left side coal so
that the pilot flame will be
visible. (See figure 36).
4.2
Place the
three remaining
medium size coals
behind and
approximately midway
between each of the
coals in the front row
(See figure 37).
4.3
Place the two
remaining small coals
alongside the main coals
(See figure 38)
Fig 38 Small side coals
Fig. 37 Middle row of coals
Fig. 35Rear base coal
installation
Fig. 36 Front row of coals
Fig. 34 Tray trim & front
base coal installation
Fig. 33 Ceramic rear wall
installation
