Page 9
www.wolverineairsoft.com
Next slide the baffle off of the
nozzle/poppet assembly and pull
out the spring.
Lubricate the 1.5mm x 16mm
O-ring located below the
threads and the 1mm x 13mm
O-ring located above the
threads.
If for some reason the two
piece baffle comes part you
can simply slide the two halves
back together. Make sure that
the 1mm x 13mm O-ring is still
in place on the lower half of the
baffle when you do so.
Your Inferno is ready to re-
assemble. Begin by sliding the
poppet and nozzle assembly into
the baffle. Then install the 1mm
x 10.5mm O-ring around the
nozzle. Then slide the baffle and
nozzle back into the cylinder.
Lubricate the 1mm x 13mm
O-ring around the poppet base.
Note: the nozzle and poppet as-
sembly does not come apart.
