LUMINOUS™ 570 SERIES LED LIGHT BAR - PAGE 1
Your purchase of a Wolo warning light is the perfect choice to complement your vehicle. Wolo’s warning lights
are manufactured with the finest materials. Before being packaged, each light is tested to meet our high
standards and ensure a perfect working light. Our quality workmanship and components are Wolo’s assurance
that this product will provide years of dependable service. If you need help or have any questions using your
new Wolo warning light, our technicians are available to answer your questions, Monday thru Friday, from 9 AM
to 4 PM EST at 888-550-4676.
Before installation of the light bar is attempted, it is important to read the installation manual completely. The
lives of people are dependent on a proper installation of the light bar to the vehicle. The person installing
this light bar must have advanced knowledge of the proper method for mounting and securing a light bar to
a vehicle’s roof or exterior, as well as knowledge of the vehicle’s electrical system. Again, read this manual
completely and note any messages marked “IMPORTANT”, “WARNING’’ or “NOTICE”. A safe installation will
prevent serious injury or damage to the vehicle.
LUMINOUS comes completely wired and does not require any internal wiring by the installer. The light bar
has two electrical cables exiting from the bottom of the light bar. The thinner cable has a factory installed
waterproof plug that will ensure a successful installation and years of dependable service.
Installation of the LUMINOUS Light Bar requires drilling into the vehicle’s roof and interior. The installer must
carefully inspect both sides of the selected locations to ensure that there are no components, wires and/or any
other vehicle part that could be damaged by drilling. IMPORTANT: Always de-burr any drilled holes, ensuring that
there are no sharp edges. Install a rubber grommet into all metal holes that the wires are being routed through.
IMPORTANT: Always refer to the vehicle’s shop manual for deployment location of the air bags. Never install
the light bar’s switch control panel, wires and or components in the deployment area of any air bag. Improper
installation could reduce the effectiveness of the vehicle’s air bag system and/or project an object that could
cause serious personal injury, or death to driver and passenger. The user/installer assumes all responsibility to
properly access a safe mounting location of the light bar’s switch control panel, so to provide ultimate safety to
the driver and passengers inside the vehicle.
The vehicle operator and/or maintenance department should inspect the light bar frequently to ensure all
brackets and bolts are securely attached to the vehicle and that all mounting hardware is free of corrosion.
The light bar’s switch control panel should be mounted in a location where the switches can be easily reached.
Never attempt to power the light bar on/off while driving under hazardous conditions.
These installation instructions should always be kept and stored in a safe location so that they can be referred
to when information, maintenance or reinstallation is required.
Failure to follow all safety precautions and installation procedures outlined in these instructions could result in
property damage to the vehicle, serious injury or death.
MOUNTING THE LIGHT BAR
There are two methods to safely mount the light bar to the vehicle’s roof. The light bar can be mounted directly
to the vehicle’s roof or a flat surface using the slide brackets, or using the provided stainless-steel straps that
will secure the light bar to the vehicle’s windows ledge.
570 Series LED LIGHT BAR
LED LIGHT BAR INSTALLATION MANUAL
TM
