67
6.
The oven is ready for operation again.
CAUTION!
To
switch off the oven completely
the rotary knobs of the
oven function
and
of the temperature control must be set to position
0
. If
the rotary knobs are not set to position
0
while resetting the oven, the oven
starts to heat again.
S
ELECTION OF THE END OF THE COOKING
/
BAKING TIME
:
❖
This function allows you to select
the time of the day
by which the oven will be
switched off automatically.
❖
The maximum settable time of the day for the end of the cooking / baking time
is 10 hours from the current time of the day.
❖
Cooking Time setting Range is 0:00
–
10:00.
❖
Not setting cooking time after power on ,the appliance will automatically shut
down after working 10 hours, without buzzer reminding function.
Description of the respective numerations: s. chapter 3.2.4 D
ISPLAY
1.
Place the food to be cooked or baked in the oven and close the door properly.
2.
Select the desired oven function (s. chapter 3.6
FUNCTIONS OF THE OVEN
) and
oven temperature using the corresponding rotary knobs (
C
/
E
// s. chapter 3.2.3
C
ONTROL PANEL
).
3.
Press the programme button
(
6
)
four times
.
4.
The decimal points of the clock (
3
) are flashing.
5.
The operational status indicator "
OVEN IN USE
" (
2
)
on the display
goes on.
6.
The indicator "
AUTOMATIC COOKING
" (
1
) goes on.
7.
The display indicates
00:00
.
8.
Set the desired
time of the day
by which the cooking / baking process
should
be finished
using the buttons
+
(
5
) and / or
-
(
7
).
9.
If the desired time of the day is displayed, release the
+
/
-
buttons.
10.
The cooking process starts immediately
and the countdown starts a few
seconds later.
11.
If the set time of the day has been reached, an acoustic signal sounds and the
oven will be
switched off automatically
.
12.
The indicator "
AUTOMATIC COOKING
" (
1
) and the indicator of the
TIMER
(
4
) are
flashing.
13.
You can switch off the acoustic signal by pressing any button on the display.
14.
To
switch off the oven,
the oven function knob
and
the temperature control
knob
must
be set to position
0
.
