16
15
Troubleshooting
If a problem is found during operation, please check unit according to
the following table:
TROUBLE
CHECK
Troubleshooting (cont.)
The induction cooker will stop due to any of following malfunctions.
After 3 seconds, the display will show the error code. You can clear the
display by pressing the ON/OFF button, and the appliance will enter the
standby state.
Display
Direction
E0
Ensure the pot or pan is placed correctly
E1
The circuit has malfunctioned
E2
The temperature sensor is opening circuit or
short circuit
E3
The voltage is higher (140V-160V)for 3 seconds
E4
The voltage is lower (80V-100V) for 3 seconds
E5
The cook-top surface temperature is too high
E6
Internal Electronic Temperature is higher than normal
for 3 seconds
E7
Internal Electronic Temperature sensor is opening
circuit or short circuit
If error codes E1 through E7 continue, contact our customer service
department at 1-800-275-8273.
When plug is inserted into the
power outlet, a beep does not
sound and the indicator does not
light when POWER button is
pressed.
Continuous 15-second beep
sounds and then the unit stops
operating.
Whether the pan is made of a
suitable material.
Whether the pan is centered on
the hotplate.
Whether the bottom diameter of
the pan is more than 5 inches.
Whether ambient temperature is
very high.
Whether vent needs cleaning.
If using in the TEMP setting, the
set temperature has been reached
and is being maintained.
That the unit has not shutoff
automatically due to a safety
issue; wait 10 minutes and
try again.
That the pan you are using has a
flat bottom.
Whether power indictor is lit.
The temperature cannot
be controlled when frying or
grilling food
The unit stops heating suddenly
during use.
That the plug has not been
removed from the outlet.
Whether circuit breaker or fuse in
your home is tripped.
Whether power is cut off.
FCC Compliance
This equipment have been tested and found to comply with the
limits for consumer ISM equipment (Radio Waves of Industrial,
Scientific, Medical Equipment), pursuant to Part 18 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the
following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet that is not on the same
circuit to which the receiver is connected.
•
Consult our customer service department at 1-800-275-8273.
HSN InductionCooker Manual 10/9/07 9:35 PM Page 15