wolfappliance.com
|
9
Anti-Tip Bracket
To prevent the unit from tipping forward, the anti-tip bracket
must be installed. To ensure the anti-tip bolt engages the
bracket, position the bracket 3"
(76)
from the left side of the
opening. Refer to the illustration below.
INSTALL BRACKET
Drywall application
|
After properly positioning the anti-tip
bracket, mark holes, then use a Phillips screwdriver or a low
rpm power drill to drive the wall anchor into the surface of
the wallboard until flush. Pre-drill holes if needed. For hard
wallboard or double-board construction, use a
1
/
4
" drill bit.
For solid plaster, use a
7
/
16
" drill bit. Refer to the illustration
below. Use #8 screws and flat washers to fasten the bracket
to the wall.
Wood floor application
|
After properly positioning the
anti-tip bracket, drill
3
/
16
"
(5)
pilot holes through the floor.
Use #12 screws and flat washers to secure the bracket to
the floor.
Concrete floor application
|
After properly positioning
the anti-tip bracket drill
3
/
8
"
(10)
holes into the concrete a
minimum of 1
1
/
2
"
(38)
deep. Use
3
/
8
" wedge anchors to
secure the bracket to the floor.
INSTALLATION
7
/
8
"
(22) MAX
ANTI-TIP
BOLT
ANTI-TIP
DEVICE
ENGAGED
Anti-tip bolt adjustment.
Anti-tip bolt engaged.
ANTI-TIP BOLT ADJUSTMENT
Once the bracket is secure, adjust the anti-tip bolt so the
top of the washer is
7
/
8
"
(22)
maximum from the floor. Slide
the range into the opening and verify the anti-tip bolt is
engaged. Refer to the illustrations below.
3"
(76)
ANTI-TIP
BRACKET
ANTI-TIP
BRACKET
WALL
ANCHOR
Anti-tip bracket location.
Wall anchor installation.
