IMPORTANT NOTE:
The screws should be
countersunk so that they are below flush.
Install the flat metal hood retaining brackets
to the wood mounting support at the loca-
tions shown in the illustration and the chart
below. Use the provided #10 X 1
1
/
2
" (38)
screws and washers to secure these
brackets in place. The metal bracket should
be mounted
1
/
2
" (13) above the top of the
wood mounting support.
IMPORTANT NOTE:
The location of this wood
mounting support and retaining bracket allow
for
1
/
2
" (13) clearance at the top of the hood for
ease of installation. This gap will be taken up
during final mounting of the hood to the wood
mounting support.
Refer to the illustration below for the location
of mounting holes for the Pro 24" (610) and 27"
(686) deep wall hoods.
15
Dimensions in parentheses are in
millimeters unless otherwise specified.
I N S TA L L AT I O N
I N S T R U C T I O N S
A C C E S S O R I E S
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Showroom
Locator section of
our website,
wolfappliance.com.
If wall framing is not available, wall
anchors must be used.
4
7/16
"
(11
3
)
2
1/2
"
(64)
MOUNTING
HOLE
S
Location of mounting holes
2 4 " ( 6 1 0 )
A N D
2 7 " ( 6 8 6 )
W A L L H O O D S
S T E P 2 : W A L L P R E P A R A T I O N
Construct the wood wall framing flush with
the wall studs and centered in the location
that the hood will be mounted. Finish the
wall surface.
Attach the provided wood mounting
support. Refer to the illustration and the
chart below. The wood support should be
centered within the desired hood location.
Use the provided 3" (76) screws to attach
the support to the wall. The location of
these screws should correspond to the
wood supports within the walls or the
framing.
Framing must be tied together to provide
enough structural strength to support the
weight of the hood and internal blower, if
applicable.
A
CENTER LINE
OF HOOD
LOCATION
B
TO BOTTOM
OF HOOD
30"
TO
36"
(762–914)
BOTTOM OF
HOOD TO
COUNTERTOP
A
3
5/8
"
(92)
3/4
"
(19)
1/2
"
(13)
HOOD RETAINING
BRACKET
Wood mounting support
Wood Mounting Support
Hood Width
(A)
(B)
30" (762)
11
3
/
4
" (298)
15
1
/
8
" (384)
36" (914)
12
1
/
4
" (311)
15
1
/
8
" (384)
42" (1067)
15
1
/
4
" (387)
15
1
/
8
" (384)
48" (1219)
18
1
/
4
" (464)
15
1
/
8
" (384)
54" (1372)
21
1
/
4
" (540)
15
1
/
8
" (384)
60" (1524)
24
1
/
4
" (616)
15
1
/
8
" (384)
66" (1676)
27
1
/
4
" (692)
15
1
/
8
" (384)