12
W O L F
P R O WA L L V E N T I L AT I O N
H O O D S
L OW- P R O F I L E
W A L L H O O D S
If you are using WBLOWER-50INT, refer to
installation instructions provided with the
blower and follow instructions for horizontal
and vertical discharge. Install the blower in
the hood before mounting the hood to the
wall.
Remove the filters by pushing each filter up
at the angle it is placed in, and rotate down.
Remove the center filter first. Gloves should
be worn to provide the proper grip when
removing filters.
If you are using an inline or remote blower,
attach the optional accessory 10" (254)
round transition or custom piece to the top
of the wall hood using holes provided.
If you are installing an in-line or remote
blower, drill a
7
/
8
" (22) hole through the
wood framing for the conduit. Refer to the
in-line and remote blower information on
pages 22–23 and follow installation instruc-
tions provided with the blower.
IMPORTANT NOTE:
Do not run wiring for the
remote blower through the ductwork.
S T E P 4 : H O O D I N S T A L L A T I O N
IMPORTANT NOTE:
If a backsplash is to be
used, it should be installed before the wall
hood is mounted. Refer to the instructions
included with the kit for complete mounting
instructions.
Install the wall mounting brackets as shown in
the illustration below. Hang the wall hood on
the installation brackets in preparation for
attaching the hood to framing.
Position the hood in the desired location on
the wall. Depending on the application, install
the #10 x 1
1
/
2
" (38) screws with washers or
3" (76) drywall screws through the mounting
holes on the back plate. Verify that the screws
engage the wall studs or framing. If not, wall
anchors must be used.
IMPORTANT NOTE:
If additional support is
required for the wall hood, drill supplementary
mounting holes in the back plate and use these
holes to attach the hood assembly to the wall
framing.
Due to the weight of the wall hood, be
sure to have adequate manpower for
installation.
WIDTH OF HOOD
26
1/4
"
(667)
TO
MOUNTING BRACKET
HOLE CENTERS
13
1/8
"
(333)
HOOD CENTERLINE
USE ROUND
AND SLOTTED
HOLES TO
SECURE HOOD
TO WALL
STUDS
MOUNT
BRACKETS TO
WALL FRAMING
7
7/16
"
(189)
TO TOP OF
BRACKET
Hood installation—vertical discharge
WIDTH OF HOOD
26
1/4
"
(667)
TO
MOUNTING BRACKET
HOLE CENTERS
22
1/2
"
(572)
CENTERED ON HOOD
9
1/2
"
(229)
CENTERED
ON HOOD
13
1/8
"
(333)
HOOD CENTERLINE
USE ROUND
AND SLOTTED
HOLES TO
SECURE HOOD
TO WALL
STUDS
MOUNT
BRACKETS TO
WALL FRAMING
7
7/16
"
(189)
TO TOP OF
BRACKET
WALL HOLE
CUT-OUT
Hood installation—horizontal discharge
