Pro Island Hood Installation
15
wolfappliance.com/specs
In-Line and Remote Blowers
WIRING FOR IN-LINE OR REMOTE BLOWER
1)
Remove the hood electrical box cover. Run Romex
®
wire from a 120 V AC, 15 amp circuit to the hood
installation location. Insert the Romex
®
wire into the
electrical box by running it through the wire clamp
previously installed. Tighten the wire clamp to secure
the wire. Refer to the illustration and chart on the
previous page for the location of wiring for your
specific hood.
2)
Run the blower cable to the installation location. Insert
the blower cable into the electrical box by running it
through the other wire clamp previously installed.
Tighten the wire clamp to secure the cable.
3)
Cut off the butt crimp connector from the end of
orange wire in hood. Strip orange wire about
3
/
8
" (10).
Using an appropriate wire connector (not included),
connect black wire from blower to orange wire in hood.
4)
Using the wire connectors provided, connect black
wire to power supply black wire, all white wires
together and green or bare wires from power supply
and blower to green ground screw in the electrical box.
5)
Place all wiring connections inside the electrical box
and reinstall the cover. Make sure all wires are secure
and that no wires are pinched between the cover and
electrical box.
Before making electrical connections, make sure the
electrical power is turned off at the service panel.
Do not run wiring through the ductwork.
