4
To insert batteries use a Philips screwdriver and open
2 screws on battery compartment. When inserting new
batteries always replace all of them and turn off Alarm
before replacing. After use of Alarm in damp conditions
leave to dry out somewhere warm before packing away
and if not going to be used for a while it is recommended
to remove batteries in case of leakage. Be careful when
attaching Alarm to banksticks, buzz bars etc. and avoid
over-tightening. See website for full care advice and
instructions.
BATTERY LEVEL
The Battery Level of the
Bite Alarm can be
displayed by pressing .
To power up the
Bite Alarm, turn the
sensitivity knob away
from the Off position.
On start-up the battery
level is indicated.
To turn off the Bite
Alarm, switch the
sensitivity knob to Off.
Await the shutdown
tone to confirm.
NOTE: Hard case will
not shut off Alarm.
INSERTING BATTERIES
POWER ON
3 AA 1.5v
Batteries
Battery
Cover
RUBBER SOCKET HOLDERS
When IQ Port or Smart LED Port are
not being used the rubber socket
holders should be pressed into ports.
When not needed they should be
pressed into the socket holders on
reverse of Alarm.
Good battery level
OK battery level
Bad battery level
