6
|
English
TOP COVER
Insert the downdraft plug into a grounded (earthed) recep-
tacle, then check operation. Once operation is verified, raise
the chimney and install the top trim using the three nuts
provided. Verify the top trim is properly aligned with the side
covers. Refer to the illustration below.
FILTERS
Remove stickers and shipping brackets and install filters.
Refer to the illustration below.
TOP COVER
MEL
T
HIGH
OFF
ON
OFF
ON
SIM
HIGH
OFF
ON
SIM
HIGH
BRID
GE
OFF
ON
SIM
HIGH
ZON
E 2
CLEA
R
OFF
O
ZONE
2
ZONE
3
HIGH
SIM
OFF
ON
Top cover installation.
Filter installation.
Installation
CONTROL MODULE
1
Use the template provided on page 7 to mark holes for
mounting screws. Drill one 40 mm in the center and two
10 mm holes for the mounting screws.
CAUTION
Verify the scale of the template if not using the installa-
tion guide shipped with the downdraft.
2
Check countertop thickness to make sure threaded
studs are long enough to allow thumbnuts to fully
engage. Thicker countertops may require the countertop
be countersunk from below.
3
Place the control module on the countertop then secure
using the two nuts provided. Once secure, install the
ground wire and nut.
4
Use provided cable or cable designated by local codes.
Connect one end of the control cable to back side of
control module and other to electrical connection on
front of downdraft assembly. Ensure all connections are
tight.
WARNING
Do not connect to telecommunication network.
RJ45
CONNECTOR
GROUND
RJ45
CONNECTOR
GROUND
NUT
CONTROL MODULE
COUNTERTOP
Downdraft connection.
Control module connection.
INSTALLATION
Troubleshooting
IMPORTANT NOTE:
If the downdraft ventilation system does
not operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the downdraft.
•
Verify proper electrical connections.
•
If the downdraft does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
downdraft. Wolf is not responsible for service required to
correct a faulty installation.
