
10
I N S T A L L D U C T C O V E R
1)
Duct cover must be installed to
ceiling prior to hood installation
2)
Use (4) ⁄" x 3" lag screws provided
with hood to attach duct cover to ceil-
ing frame work. See page 3 for addi-
tional dimension information.
3)
Install additional #10 x 2" screws
for support along top edge of duct-
cover and ceiling.
4)
Install (4) 5/16" bolts, provided
with duct cover, through hood
mounting holes into bottom edge of
duct cover. Use 5/16" nuts supplied
with duct cover and tighten on bolts.
Use #12 x 7/8" hex head self tapping
screws provided with duct cover to
attach duct cover to hood assembly
P
R O
S
E R I E S
I
S L A N D
H
O O D S
I
N S T A L L A T I O N
I N S T A L L H O O D F I L T E R
A N D D R I P C U P S
Hood Filters and Drip Cups Install
1)
Reinstall hood filter center bank
with screws removed prior to installa-
tion of hood assembly.
2)
Remove all packaging material
from filters and drip cups.
3)
Slide drip cups along bottom edge
of hood opening so lip overhangs
slightly.
4)
Lift filters into place. Lines of fil-
ters must run vertically and align with
drip cups.
5)
Adjust filters to fill space by sliding
filters left to right.
CAUTION
Installing a duct cover assembly
will impact all aspects of hood
installation including hood loca-
tion, ducting, electrical place-
ment and adequacy of mounting
surfaces.
I N S T A L L L O G O
The nameplate is not pre-assembled
because there are various locations that
the logo can be installed. Additionally,
some customers prefer not to have a
nameplate on their hood. For your
convenience, Wolf has created a tem-
plate for a standardized logo location.
Please see the back page of these
installation instructions for Wolf logo
template.
1)
Decide on the location for the
nameplate.
2)
Clean mounting area with rubbing
alcohol.
3)
If desired, cut-out template for
nameplate location.
4)
Fold template, locate placement on
hood and tape to hood surface.
5)
Check alignment and adjust if nec-
essary.
6)
Remove backing paper from name-
plate.
7)
Position nameplate in template
cutout and press into place.
8)
Remove template and any tape
residue.
OPTIONAL
DUCT
COVER
1/4" x 3" Lag Screw
5/16" SS Nut
5/16" SS Screw
#1/4" x 7/8" #12
self-tapping hex screw
2" #10 hex screw
Duct cover installation
Содержание I363418
Страница 1: ...P R O S E R I E S I S L A N D H O O D S I N S T A L L A T I O N I N S T R U C T I O N S...
Страница 14: ...14 CUT OUT FOR LOGO PLACEMENT BOTTOM EDGE OF HOOD FOLD LINE FOR LOGO PLACEMENT LEFT OUTER EDGE OF HOOD...
Страница 15: ...Wolf Appliance Company LLC P O Box 44848 Madison WI 53744 800 332 9513 www wolfappliance com 805050 7 03...