Wolf CGB-100, Инструкция по эксплуатации, Страница: 66 / 100

66 3061741_201712.indd
Conversion to other gas types
Note:
During the conversion from natural gas to LPG, a flue gas orifice plate must also be installed in the condensate pan as
follows. During conversion from LPG to natural gas, the flue gas orifice plate must be removed. This installation step
is carried out prior to the installation of the mixing chamber and full assembly.
Slide the balanced flue locking mechanism in the direction
of the arrow. Pull the flue pipe up out of the condensate
pan.
9)
11)
Updating the type plate
Cut out the relevant lines from the type plate supplied
and affix them over the relevant lines on the appliance
type plate.
Conversion type plate Figure: Updating the type plate
After removing the upper casing cover, undo the self-
tapping screw at the balanced flue locking mechanism.
8)
Conversion sets for CGB-75/100 for conversion to other gas types: (Please state the corresponding part number when ordering)
Place the Ø 53 mm flue gas orifice plate into the condensate
pan and reinsert the flue pipe.
Note: During conversion from LPG to natural gas, the
flue gas orifice plate must be removed. Fit the
mixing chamber as described under point 6).
Re-assemble in reverse order.
10)
Flue gas orifice plate
Conversion to natural gas H (G20) Part no. 86 10 471 ID 1000*
Conversion to LPG P (G31) Part no. 86 12 714 ID 6.7*
Conversion from LPG P (G31) to natural gas E/H (G20) Part no. 86 12 863 ID 1000*
Conversion from LPG P (G31) to natural gas LL** (G25) Part no. 86 12 863 ID 1260*
* ID imprinted on gas restrictor