Gas Range Installation
17
wolfappliance.com/specs
Level the Range
IMPORTANT NOTE:
The top of the range must be level.
Use both the adjustable front legs and the adjustable rear
casters to level the range.
The front legs of the range are adjusted by rotating the
bottom hexagonal portion of the leg. The rear casters can
be adjusted by rotating the nut on the caster. Using the
height adjustment wrench (supplied with the range), rotate
the nut clockwise to raise the range or counterclockwise
to lower. Refer to the illustration below. The range legs and
casters allow for a 1" (25) height adjustment.
CASTER
ADJUSTMENT
HEIGHT
ADJUSTMENT
WRENCH
Rear caster adjustment.
Verify Range Operation
IMPORTANT NOTE:
Prior to operating the range, be sure
to read the entire Wolf gas ranges use & care guide
included with the range for important safety, service and
warranty information.
SURFACE BURNERS
Place the burner parts on each burner base and position
the burner grates before lighting.
Surface burners of the gas range use electronic igniters.
When the control knob is pushed in and turned to the
HIGH position, the system creates a spark to light the
burner. This sparking continues until the electronic ignition
senses a flame.
To check operation of the surface burners, push in and
turn each control knob to the HIGH position. The flame
should light within four seconds.
If the burners do not light properly, turn control knobs to
the OFF position. Check that burner parts are in the
proper position. Make sure electricity is being supplied to
the range and that the gas shut-off valve is in the open
position. Check operation again, waiting at least five
minutes; if the burners still do not light properly, contact a
Wolf authorized service center.
IMPORTANT NOTE:
Initial lighting of the surface burners
may take slightly longer, as air in the system must be
purged before gas can be supplied to the burner.
OVEN OPERATION
Turn the oven(s) on and verify that they are coming up to
temperature. Refer to the Wolf gas ranges use & care
guide for additional information.
IMPORTANT NOTE:
A small amount of smoke and odor
may be noticed during the initial break-in period.
