System Installation
1.
Main Panel
Plug the horn into faucet on the back side , telephone line into line-in faucet,
joint telephone and the panel through line-out faucet, plug the power supply ,
turn on the switch, then done with the installation. Press the key
【
Unlock
】
to
let panel in disarming status for fear that it alarma when user install door
magnet and P.I.R. You can hear one beep in gear when the power supply switch
is turned on. The panel will beep one time every 30 seconds to remind of
recording alarm message and telephone numbers. Beep will stop once the set is
over.
2.
Door Magnet
It will apperceive open -close of door or windows. Fixing magnet and transmit
box separately on the door and doorcase with double-face sticker. ( suggestion:
you’d better fix it with screw due to sticker invalidation after long-time use) Pay
attention to keep the space between transmit box and magnet no more than
2mm .
3.
P.I.R
The device could detect human body move within certain range. Fixing it on the
wall of main passage or important zone and avoiding direct light irradiation
whenever in the day or night. Also it should be kept away from air conditioner
and stove, etc. Its installation height is suggested within 2 to 2.2 meters and its
detection angle should be adjusted face to detector zone directly. P.I.R goes to
work after 1 minute warm-up once turning on the power supply switch. (notice:
installation position will cause the alarm veracity)
4.
Intelligent Remote Control Switch
Tear open the opposite electronic appliance switch panel and fix current panel if
you want remote control . The current device supply throttle unit for you to
control daylight lamp, parallel connecting at two ends of the lamp.
5.
Joint Wired Detector
The main panel has 7 wired detector faucets, the + - terminal are anode and
cathode of 12V direct current output which loads maximum 200 mA current.
Connect one end of signal line to anode while the other end to opposite faucet.
A-G mean 1-7 defense zones. There are no delay for wired defense zone.
System Setup
1.
Record Alarm Message
Under disarming status, press the key
【
Record
】
on the back of main panel and
keep 3 seconds, starting to record toward the panel after hearing one beep . The
leave word time should be 10 seconds , and the two beeps (a shorter one and a
longer one)