Wolf Garten Compact plus 40 B, Инструкция по эксплуатации

Страница: 14 / 36

14 15
Operation
Emptying the grass bag O
Only when mower is stationary and rotating blade
has come to complete standstill.
• When the grass bag is full, the flap lowers automatically.
• To ensure proper functioning: clean the holes beneath
the level indicator in the grass bag regularly with a hand
brush.
Mulching
Mowing
Hanging the grass bag N
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective flap
„Mulching“ is a process in which the grass is finely chop-
ped by a special cutting system and then deposited on the
ground. The result is that the grass does not have to be
collected and disposed of. „Mulching“ also prevents the lawn
from drying out.
Note:
• Depending on how fast the grass grows, you should mulch
1-2 times each week.
• The grass should not be too high or very wet!
• Walk slowly.
• When cutting, the strips should overlap.
• Do not cut more than 20 cm of grass at a time.
Important!
„Mulching“ is not recommended if the lawn is mossy or
matted.
Reason:
The cut grass remains on top fo the moss or matted grass
and cannot reach the ground below.
Remedy:
The lawn should be aerated and fertilized regularly.
Operating times
Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
F G
1. Lift and hold operator presence bail arm (F, 2).
2. Pull the starter rope slowly to the holding bracket.
3. Twist the cord through the holder (G).
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
H
Check oil level regulary before mowing!
To check, do not screw in the dipstic k.
Fill crankcase with quality oil SAE 30 up to the marking „Full“
on dipstick.Capacity approx. 0,6 litre . Lift mower slightly on
the oil filter side whilst pouring oil slowly.
Filling with Petrol
Do not smoke - no naked flames!
Switch off engine.
Avoid spilling petrol when engine is warm.
Use „low-octane petrol“ (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Use of height adjustment J
Only when mower is stationary and rotating blade
has come to complete standstill.
Place hand into handle bar and depress button (1). Lift or
lower chassis until it engages into required position (2).
Tips for mowing L
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
• Always turn the mower on a surface that has already been
mowed.
If possible, mow when grass is dry in order to protect turf.
Do not set cutting position too low when mowing very tall or wet
grass. We recommend an average cutting height of 4,0 - 5,0 cm.
Start
F G K
• On a flat surface, if possible not in high grass.
Cold start
1. Set hand throttle (F, 1) on operate.
2. Firmly press the primer on the motor (K) three times.
3. Raise and hold the safety bracket (F, 2).
4. Pull starter grip (G) and return it slowly by hand.
Wheel drive (only Compact plus 40 BA)
1. Wheel drive on: Raise drive bracket (F, 3).
2. Wheel drive off: Relapse drive bracket (F, 3).
Warm start
1. Raise and hold the safety bracket (F, 2).
2. Pull starter grip (G) and return it slowly by hand.
Stop Motor
Release safety bracket (F, 2).
• If the motor does not start in cold weather, press the primer.
• If the motor stops due to lack of fuel, refill with fuel and
press the primer firmly (three times).
General
Activating the cut/ collect function M
Make sure the motor is switched off and the
cutting blade is not moving.
• Turn the switch to „CUT/COLLECT“.
Activating the mulch function M
Only when the motor is switched off and the
cutting blade is not moving.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH“.