Wohler AMP2-16V-M, Руководство пользователя

Страница: 162 / 172

Page 155
APPENDIX B: Ravenna Network Setup
Introduction
Installing the AMP2-16V into an existing and functioning Ravenna network is
virtually plug and play. The AMP2-16V Ravenna input module supports 1Gb/s and
100Mb/s Ethernet devices in Ravenna Audio over IP network configurations. AMP2-
16V channel source selections are made by choosing Source Pair Select ‘Ravenna’
in the Monitor Mixer Configuration Menu as shown in Figure B-1.
Figure B-1: AMP2-16V Source Pair Selection
Monitor Mixer Configuration Menu
Save / Exit Help Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 Ravenna
Pair 4
Slot 2 Ravenna
Pair 5
+0 +0 +0 +0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
Note: In addition to the AMP2-16V configuration, the Coveloz Bach board needs to
configured using its own configuration tool. The menus in this configuration tool are
shown in this Appendix.
Note: The instructions provided in this appendix are intended only as an overview.
Detailed instructions may be found in the Coveloz Manual.
Ravenna Input Module Features
The AES67 enabled Coveloz Bach board supports the following features:
RAVENNA-Compatible Listener
The Ravenna Input Module for the AMP2-16V offers the following features:
5) RFC 3551 – RTP Profile for Audio and Video Conferences
a) L16 16-bit linear format defined in RFC 3551 clause 4.5.11
b) L24 24-bit linear format defined in RFC 3190 clause 4
c) AM824 24-bit Audio as defined in IEC61883-6
d) Multicast and unicast session support