© 2006 Wohler Technologies Inc. ALL rights reserved
26
AMP-S8
User Manual P/N
821640
Rev-
B
User Interface Function Guide
Selection Modes
(Cont.)
Presets:
Presets
may be recalled, created, and replaced by either using the
PRESETS Buttons 1-4
or by menu selection in
Setup
Mode
. Presets can only be erased in
Setup Mode
. See page
29-30
for how to recall, create, and erase presets within
Setup
Mode
.
Recalling a Preset:
FN Button
+
PRESETS Button 1-4
PRESETS Buttons 1, 2, 3, 4
may be used to recall P
resets
1-4
respectively, by pressing and holding the
FN Button
and then pressing the corresponding
PRESETS Button
(
1-4
)
. This allows the user the option to recall that preset with the
following prompt.
RECALL PRESET?
RECALL PRESET?
RECALL PRESET?
RECALL PRESET?
RECALL PRESET?
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Pressing the
ENTER
Button
at this point will recall that preset.
Creating (Overwriting) a Preset:
If you do not wish to recall the preset at the prompt indicated above (
Recalling a Preset
), then pressing the
Button
invokes a prompt to save (overwrite) the current state of the unit over that preset as follows:
OVERWRITE PRESET
OVERWRITE PRESET
OVERWRITE PRESET
OVERWRITE PRESET
OVERWRITE PRESET
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Preset1: Off Air
Pressing the
ENTER
Button
at this point will prompt the user whether to Keep Old Name, where the existing name can be
retained by pressing
ENTER
. If the user presses
ES C
, then they will be prompted for a new preset name as follows:
AES 1 ?@<A>BC
AES 1 ?@<A>BC
AES 1 ?@<A>BC
AES 1 ?@<A>BC
AES 1 ?@<A>BC
Name: A_
Name: A_
Name: A_
Name: A_
Name: A_
If the user presses the
ENT
Button
before finishing the naming, then the preset is not saved and the existing preset is retained. To
enter the new name, select letters using the
L UP
and
L DOWN Buttons
or
R UP
and
R DOWN Buttons
. The current
selectable character appears between the
< >
symbols. Press the
ENTER
Button
to accept the current letter and move
to the next letter. Naming will automatically end after eight characters are selected, or naming can be ended by pressing the
ENTER
Button
when the
_
DONE
_
selection appears. The
DONE
selection comes before the numerals, and follows the
lower case alphabet. The character order is the order of ASCII characters. A chart showing the character order appears in
the
SAVE Preset
section on page
29
.
Upon completion of naming the preset, the current state of the system is saved under that name and preset number. At any
time during this process the user may press the
ESC
Button
and the preset will not be saved and the unit will return to
Normal
Operation Mode
.
See page
29-30
for more information about creating, naming, recalling, and erasing presets from the menu in
Setup Mode
.
SDI GROUP Definition:
NOTE:
The embedded channels within an
SDI
signal are defined and referred to in this manual as shown in the chart below:
Section 2:
Operation
