WMH Tool Group JET JWBS-18X, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 36

10
Assembly and Setup
1. Attach the handle (A, Figure 1) to the
handwheel (B, Figure 1).
2. Turn blade tension handwheel (C, Figure 1)
counterclockwise to tension blade and
clockwise to loosen the tension. A gauge
on the upper wheel slide bracket (D, Figure
1) indicates the approximate tension
according to the width of the blade. The
JWBS-18X comes with a 3/4” blade so the
tension should be set at 3/4”.
Note: It is easier to adjust the bearing guides
before mounting the table.
Upper Bearing Guide Adjustment
Disconnect machine from
power source (unplug) before making any
adjustments! Blade teeth are sharp - use
care when working near the saw blade.
Failure to comply may cause serious injury.
1. Blade tension must be properly adjusted
prior to bearing guide setup. See “Adjusting
Blade Tension” on page 16.
2. Adjust the back-up bearing (E, Figure 2) so
that it is 0.003” away from the back of the
blade, about the thickness of a piece of
paper. To make this adjustment loosen
thumb screw (F, Figure 2) and slide the
bearing and bearing post into position.
Tighten thumb screw.
3. Loosen the socket head cap screw (G,
Figure 3) and slide the bearing assembly
until the bearing guides rest just behind the
gullet of the blade teeth. You may need to
readjust the back-up bearing (E, Figure 2).
4. Loosen the wing nut (H, Figure 3) and turn
the adjusting screw (I, Figure 3) clockwise or
counterclockwise until the bearing is 0.003”
away from the side of the blade, about the
thickness of a piece of paper. Tighten wing
nut (H, Figure 3).
5. Adjust the opposite side bearing.
6. Check to make sure the adjustments have
not changed and the bearing guides do not
pinch the blade.
Figure 1
Figure 2
Figure 3